期刊文献+

考虑剩余强度的焊接箱形梁动态可靠性分析

Analysis on dynamic reliability of welded box beam with consideration of residual intensity
在线阅读 下载PDF
导出
摘要 针对目前起重机金属结构可靠性的研究未反映出可靠度随时间动态变化的特性,考察其可靠度和失效率受多级的变幅载荷影响随时间的变化过程,推导出起重机金属结构的动态可靠度计算公式。研究表明:起重机金属结构的可靠度受到应力作用次数、应力峰值和剩余强度等因素的影响,并随时间的增加而呈非线性降低的特性。本研究为起重机的寿命评估和动态监测奠定了理论基础,具有重要的工程实用价值。 Aiming at current analysis on metal structure of crane which does not reflects the dynamic change of reliability with time,in consideration of reliability and failure rate changing with time due to multilevel cyclic stress of varying amplitude,the paper deduces calculation formula for dynamic reliability of metal structure.The analysis shows that the reliability of metal structure may be affected by stress cycles,peak stress and residual intensity,and reduces in a nonlinearity way over time.The analysis lays a theoretical foundation for life evaluation and dynamic monitoring of the crane and has important practical value in engineering.
作者 何洋洋 赵星
出处 《起重运输机械》 2011年第5期19-22,共4页 Hoisting and Conveying Machinery
关键词 起重机 动态可靠性 应力强度干涉模型 剩余强度 crane dynamic reliability stress-strength interference model residual intensity
  • 相关文献

参考文献4

二级参考文献18

  • 1谢里阳,李翠玲.相关系统失效概率的次序统计量模型及共因失效原因分析[J].机械强度,2005,27(1):66-71. 被引量:18
  • 2谢里阳,周金宇,李翠玲,王学敏.系统共因失效分析及其概率预测的离散化建模方法[J].机械工程学报,2006,42(1):62-68. 被引量:23
  • 3Lewis E E. A load-capacity interference model for common mode failures in 1-out-of-2: G systems [ J ]. IEEE Transaction on Reliability, 2001,50(1) : 47 - 51.
  • 4Dillp R, Tanmoy D.A discretizing approach for evaluating reliability of complex systems under stress-strength model [J ]. IEEE Transaction on Reliability, 2001,50(2 ) : 145 - 150.
  • 5Xie L Y, Zhou J Y, Wang Y Y, et al. Load-strength order statistics interference models for system reliability evaluation [J ].International Journal of Performance Engineering, 2005,1 ( 1 ) : 22 - 36.
  • 6Ronold K O, Larsen G C. Reliability-based design of windturbine rotor blades against failure in ultimate loading[J ]. Engineering Structures, 2000,22:565 - 574
  • 7Li B, Zhu M L, Xu K.A practical engineering method for fuzzy reliability analysis of mechanical structures [J].Reliability Engineering and System Safety, 2000, 67:311 -315
  • 8Wang Z, Xie L Y. Reliability model of component under stochastic ally repeated load [ C ]//The First International Conference on Maintenance Engineering. Beijing: Science Press, 2006:895 - 900
  • 9Ditlevsen O, Stochastic model for joint wave and wind loads on offshore structures[J ]. Structural Safety, 2002,24 : 139 - 163.
  • 10Li J P, Thompson G. A method to take account of inhomogeneity in mechanical component reliability calculations [J ]. IEEE Transaction on Reliability, 2005,54 (1):159 - 168.

共引文献45

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部