摘要
Underhand cut-and-fill mining has been widely used in underground mining operations,especially when the rock mass or orebody is of poor quality or prone to rockburst due to high stress.In such cases,mining workers should carry out all production activities under the cemented backfill roof or sill mat instead of a highly fractured and unstable rock roof or a strong rock roof with a high potential of rockburst.Therefore,the stability and required strength of the sill mat are critical issues for mining engineers.In 1991,Mitchell considered that sill mat could fail by caving,sliding,rotation,and flexure.Mitchell also proposed an analytical solution to determine the minimum required strength of the sill mat for each type of failure based on two stiff or immobile rock walls.However,recent publications using numerical modeling and field measurements indicate that the compressive stresses in the sill mat induced by rock wall closure due to a stope excavation beneath the sill mat can be significant.It is thus highly necessary to investigate the required strength of the sill mat by considering rock wall closure.In this study,the crushing failure of sill mat due to rock wall closure generated by underground excavation and a new failure mode called"crushing and caving”is revealed by numerical modeling.An analytical solution corresponding to each failure mode is then developed to estimate the minimum required cohesion(cmin)of the sill mat.A criterion is also proposed to determine if the sill mat fails by crushing or crushing-and-caving failure.The proposed analytical solution does not involve any correction coefficients.The validity of the proposed analytical solution is demonstrated by numerical modeling.The proposed analytical solution can thus be employed to predict the cmin of sill mat subjected to wall closure generated by underlying stope excavation.
基金
financial support from the Young Scientist Project of the National Key Research and Development Program of China(Grant No.2021YFC2900600)
Beijing Nova Program(Grant No.20220484057)
The authors acknowledge the financial support from the Natural Sciences and Engineering Research Council of Canada(Grant No.RGPIN-2018-06902)
industrial partners of the Research Institute on Mines and the Environment(RIME UQAT-Polytechnique:https://irme.ca/en/).
