期刊文献+

温湿度对多孔含油胶木保持架性能的影响

Effects of Temperature and Humidity on Properties of Porous Oil-Containing Bakelite Cages
在线阅读 下载PDF
导出
摘要 研究了温湿度对多孔含油胶木保持架的含油率、尺寸和拉伸强度等关键指标的影响规律,结果表明:随温度升高,多孔含油胶木保持架出现一定程度的出油现象,保持架含油率降低,含油率下降速率与保持架初始含油率和孔径有关,尺寸变化率不大于0.1%,拉伸强度变化浮动在1%以内;多孔含油胶木保持架在高湿度环境下吸湿后,内外径均有所增大,尺寸变化率不大于0.2%,拉伸强度降低率不大于3%;高湿度对多孔含油胶木保持架尺寸和拉伸强度的影响大于温度。 The effects of temperature and humidity on key indicators are studied,such as oil content,size and tensile strength of porous oil-containing bakelite cages.The results show that with the increase of temperature,the cages exhibit a certain degree of oil discharge,the oil content decreases,the decreasing rate of oil content is related to initial oil content and pore size of the cages,the change rate of size is not more than 0.1%,and the change of tensile strength is within 1%;after absorbing moisture in high humidity environment,both the inner and outer diameters of the cages increase,the change rate of size is not more than 0.2%,and the reduction rate of tensile strength is not more than 3%;the effect of high humidity on size and tensile strength of the cages is greater than that on temperature.
作者 买楠楠 席博伦 李媛媛 董胤喆 孙小波 MAI Nannan;XI Bolun;LI Yuanyuan;DONG Yinzhe;SUN Xiaobo(Luoyang Bearing Research Institute Co.,Ltd.,Luoyang 471039,China;China International Science and Technology Cooperation Base for Digitization Design of High Performance Bearings,Luoyang 471039,China;Henan Key Laboratory of High Performance Bearing Technology,Luoyang 471039,China)
出处 《轴承》 北大核心 2024年第3期72-76,共5页 Bearing
关键词 滚动轴承 保持架 温度 湿度 含油率 拉伸强度 rolling bearing cage temperature humidity oil content tensile strength
  • 相关文献

参考文献7

二级参考文献48

  • 1吴扬,董浩,段跃新,肇研.湿热循环对PMI泡沫/3218-1环氧树脂夹层结构性能影响的研究[J].玻璃钢/复合材料,2012(1):29-33. 被引量:7
  • 2张武,穆颖竹,王燕,林德宽,杨美云,邓小兰.微孔聚酰亚胺球轴承保持器材料的研究[J].材料工程,1990,18(6):15-17. 被引量:5
  • 3田莉莉,刘道新,张广来,杨专钊.温度和应力对碳纤维环氧复合材料吸湿行为的影响[J].玻璃钢/复合材料,2006(3):14-18. 被引量:18
  • 4Wolff G·ERNEST.Introduction to the dimensional stability of composite materials[M] //Laster,Pennsylvania l7601.USA:DEStech Publications,2004.
  • 5Wright W W.The effect of diffusion water into epoxy resins and their carbon-fiber reinforced composites[J].Composites,1981,7:201-205.
  • 6Cook T S,Walrath D E,Francis P H.Moisture absorption in graphite-epoxy composite materials[J].SAMPE,1977,22:339-348.
  • 7Shen C H,Springer G S.Moisture absorption and desorption of composite materials[J].J.Comp.Mt,1978,10:2-20.
  • 8Gueguen F,Bettes A,Toulemont Y,et al.SPOT series camera improvement for HRG,very high resolution instrument of SPOT 5[C] //EUROPTO Conference on Design and Engineering of Optical System.Berlin,Germany,1999.
  • 9Sathyan K,Hsu H Y,Lee S H,et al.Long-Term Lubri-cation of Momentum Wheels Used in Spacecrafts-AnOverview[J].Tribology International,2010,43:259-267.
  • 10Bertrand P A.Friction at the Contact Between BearingBalls and Cotton-Phenolic Cage Material[R].Aero-space Report,2004.

共引文献64

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部