期刊文献+

中温氧化锌脱硫剂再生及其织构研究 被引量:5

Study on regeneration and texture of a mid-temperature zinc oxide desulfurizer
在线阅读 下载PDF
导出
摘要 在固定床反应器上考察了温度和氧浓度对一种商用中温氧化锌脱硫剂再生性能的影响,并进行了二次硫化实验,应用TPO,XRD,BET方法对再生前后脱硫剂的性能进行了表征分析。实验结果表明:氧化锌脱硫剂经600℃空气气氛下再生具有良好的二次吸附硫容量;再生脱硫剂的织构对脱硫性能有明显的影响;微量硫酸盐的生成造成了脱硫剂的再生不完全;600℃再生脱硫剂孔径小于10nm的微孔基本不变,而大于10nm的孔明显降低,导致了比表面积和孔体积的降低。 The effects of temperature and Oz concentration on the regeneration performance of a commercial mid-temperature zinc oxide desulfurizer were investigated with second cycle sulfuration experiment conducted in a fixed bed reactor, and the fresh and regenerative desulfurizers were characterized by TPO, XRD and BET. The results showed that 600℃ was most suitable for the regeneration of the desulfurizer in air with a good second cycle sulfur sorption capacity; the texture of the regenerative desulfurizcr mightily affected its desulfurization performance; the incomplete regeneration was attributed to the formation of some sulfate; and the regeneration of the desulfurizer at 600℃ in the air reduced the volume of the pores of above 10nm apparently but hardly affected the micropores of below 10nm, which resulted in a slight decrease of the specific surface area and pore volume.
出处 《天然气化工—C1化学与化工》 CAS CSCD 北大核心 2013年第5期67-70,共4页 Natural Gas Chemical Industry
基金 国家自然科学基金委员会创新研究群体科学基金(50921002)资助
关键词 氧化锌 脱硫剂 再生 织构 zinc oxide desulfurizer , regeneration texture
  • 相关文献

参考文献9

  • 1梁斌,王菊,曾兵.高温煤气可再生脱硫剂与脱硫过程[J].四川大学学报(工程科学版),2011,43(6):197-202. 被引量:3
  • 2侯朝鹏,夏国富,李明丰,聂红,李大东.F-T合成催化剂H_2S中毒热力学和抗硫可行性预测[J].化工学报,2011,62(3):598-603. 被引量:6
  • 3Mureddu M, Ferino I, Rombi E, et al. ZnO/SBA-15 composites for mid-temperature removal of H2S: Synthesis, performance and regeneration studies[J].Fuel,2012,102:691-700.
  • 4任文玲,陈绍云,张永春,李桂民.Zn/SBA-15介孔吸附剂的制备及脱附低浓度H_2S性能[J].化工进展,2011,30(10):2304-2309. 被引量:7
  • 5樊惠玲,刘生听,孙婷,等.氧化铁脱硫剂的织构及其对脱硫性能的影响田.中国矿业大学学撤,2012,41(1):102-107.
  • 6Untea I, Dancila M, Vasile E,et al. Structural, morpholog- ical and textural modifications of ZnO-TiO2 HTGD based sorbents induced by Al_O3 addition, thermal treatment andsulfurizing process[J]. Powder Technol, 2009,191:27-33.
  • 7Giuffrida A, Romano M C, Lozza G G. Themlodynamic assessment of IGCC power plants with hot fuel gas desulfurization[J]. Appl Energy,2010,87:3374-3383.
  • 8郭晋菊,黄戒介,赵建涛,房倚天.Ni-Zn-Fe复合氧化物脱硫剂再生研究[J].燃料化学学报,2010,38(3):352-358. 被引量:6
  • 9Garees H F, Galindo H M, Garees L J, et al. Low temperature H.-.S dry-desulfm'ization with zinc oxide [J]. Microporous Mesoporous Mat, 2010,127:190-197.

二级参考文献47

  • 1葛晓华,郭波,常丽萍.高温煤气脱硫剂的研究进展[J].工业催化,2005,13(11):6-11. 被引量:9
  • 2PINEDA M, PALACIOS J M, ALONSO L, GARCIA E, MOLINER R. Performance of zinc oxide based sorbents for hot coal gas desulfurization in multicycle tests in a fixed-bed reactor[ J]. Fuel, 2000, 79(8) : 885-895.
  • 3PAN Y G, PERALES J F, VELO E, PUIGJANER L. Kinetic behaviour of iron oxide sorbent in hot gas desulfurization [ J ]. Fuel, 2005,84 (9) : 1105-1109.
  • 4FOCHT G D, RANADE P V, HARRISON D P. High temperature desulfurization using zinc ferrite: Regeneration kinetics and rnuhicycle testing [J]. Chem Eng Sci, 1989, 44(12) : 2919-2926.
  • 5JOTHIMURUGESAN K, GANGWAL S K. Regeneration of zinc titanate H2S sorbents[J]. Ind Eng Chem Res, 1998, 37(5) : 1929-1933.
  • 6JUNG S Y, LEE S J, LEE T J, RYU C K , KIM J C. H2S removal and regeneration properties of Zn-Al-based sorbents promoted with various promoters[J]. Catal Today, 2006, 111(3/4): 217-222.
  • 7ZHANG R, HUANG J, ZHAO J, SUN Z, WANG Y. Sol-gel auto-combustion synthesis of zinc ferrire for moderate temperature desulfurization [J]. Energy Fuels, 2007, 21(5) : 2682-2687.
  • 8JUN H K, KOO J H, LEE T J, RYU S O, YI C K, RYU C K , KIM J C. A study of Zn-Ti based H2S removal sorbents promoted with cobah and nickel oxides[J]. Energy Fuels, 2004, 18(1 ) : 41-48.
  • 9Choi Do-Young,Lee Jae-Wook,Jang Seong-Cheol,et al.Adsorption dynamics of hydrogen sulfide in impregnated activated carbon bed [J].Adsorption,2008,14:533-538.
  • 10Duan Yongfeng,Xiang Yuzhi,Xia Daohong.Removal of hydrogen sulfide from light oil with solid base[J].Fuel Processing Technology,2004,86:237-244.

共引文献18

同被引文献52

引证文献5

二级引证文献12

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部