期刊文献+

双通道沿迹干涉SAR地面动目标检测 被引量:3

Dual Channels Along -Track Interferometry SAR Ground Moving Target Detection
在线阅读 下载PDF
导出
摘要 该文深入研究了双通道沿迹干涉(Along-Track Interferometry,ATI)SAR的机理,给出了运用该机理在静止目标去线性调频后的频域内进行动目标检测的方法。文中详细描述了该方法的检测过程,分析了杂波、噪声以及目标速度对检测性能的影响,最后给出了计算机仿真结果。分析及仿真结果表明, 与同常规方法相比,该方法对可检测运动目标信杂比的要求降低,对于淹没在主瓣杂波谱内的动目标以及在主瓣杂波谱外的动目标能够同时检测: 同时,在频域检测计算量下降。 This paper provides a ground moving target detection algorithm in Range-Doppler domain with Along-Track Interferometry(ATI) for dual channels SAR after studying ATI theory deeply. It describes the procedure of detection in detail and analyzes the effect of Signal-Noise-Ratio(SNR), Signal-Clutter-Ratio(SCR) and moving target's velocity. Finally, some typical computer simulation results are presented. Comparing with routine method, the method in the paper requires lower SCR of moving target, and can detects targets both in and out of the clutter main lobe frequency. In addition, it needn't compress echoes in azimuth, so the computation decreases.
出处 《电子与信息学报》 EI CSCD 北大核心 2005年第10期1560-1563,共4页 Journal of Electronics & Information Technology
关键词 沿迹干涉(ATI) 动目标检测 双通道 检测函数 Along-Track Interferometry(ATI), Moving target detection, Range-Doppler domain, Dual channels,Detection function
  • 相关文献

参考文献6

  • 1Carnade Richard E. Dual baseline and frequency along-track Interferometry. IGARSS, Houston, America, 1992:1585 - 1588.
  • 2Gill Eberhard. A formation flying concept for an along-track interferometry SAR mission. DLR/GSOC TN. 2003.
  • 3Shen Chiu. Computer simulation of Canada's RADARSAT2 GMTI. RTO SET Symposium. Greece, Held on the Island of Samos. 2000.
  • 4Gierull C H, Sikaneta Ishuwa C. Raw data based two-aperture SAR ground moving target indication. IGARSS. Toulouse,France, 2003.7: 1032- 1034.
  • 5胡广书.数字信号处理-理论、算法与实现:第3.8节[M].北京:清华大学出版社,2002..
  • 6Thompson Alan A, Livingstone Charles E. Moving Target Performance for RADARSAT-2. IGARSS, Honolulu, USA, 2000:2599-2601.

同被引文献30

引证文献3

二级引证文献10

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部