摘要
根据平面度评定标准，采用最小二乘法评定法则，对平面度在实测中得到的数据进行微机处理，提出计算框图及程序，并进行实际计算和评定，同时加以验证。该程序容易普及和使用，也可为其它形位公差的数据处理提供参考。
This paper utilises the law of the smallest binary multiplication assessment to practise computer handling of the statistics obtained by flatness measuring and to raise calculation diagram and programme in accordance with the standards of measuring flatness. At the same time, is conducts practical calculation and assessment, with its slatistics proved. This programme is easy in popularization and application. Simultaneously it also presents references for handling statistics of tolerance in size and positio...
出处
《安徽机电学院学报》
1998年第1期34-38,共5页
Journal of Anhui Institute of Mechanical and Electrical Engineering
关键词
平面度
测量
计算机
评定
flatness
measure ment
computer
assessment
