Based on the Chinese National Standards involving heat pump water heater and space heating system, performances of the R744/R290 subcritical heat pump system have been discussed and compared with those of the R22 syst...Based on the Chinese National Standards involving heat pump water heater and space heating system, performances of the R744/R290 subcritical heat pump system have been discussed and compared with those of the R22 system, which is widely used in heat pump systems in China nowadays. It can be indicated that R744/R290 mixture can work efficiently as a refrigerant for heat pumps with a large heat-sink temperature rise. When mass fraction of R290 is increased, discharge pressure is reduced. Under the nominal working condition, there is an optimum mixture mass fraction of 20/80 for R744/R290 under conventional condensation pressure. Both the heating COPhs （coefficient of performance） and volumetric heating capacity are increased by about 12.62% and 34.24% respectively compared with those of R22 based system. But for the heat sink with a small temperature rise, R744/R290 system has poorer performances than R22 system. When heat transfer pinch point in evaporator and condensation processes is considered, the degree of superheat has a negative influence upon system performances under the given conditions.展开更多
We introduce a new model of one-dimensional （1D） photonic crystal composed of alternately arranged RHM and LHM layers with positive and negative refractive indices respectively, for which the transmission spectra of...We introduce a new model of one-dimensional （1D） photonic crystal composed of alternately arranged RHM and LHM layers with positive and negative refractive indices respectively, for which the transmission spectra of the model are calculated numerically with the transfer matrix method, and the bandgap structure and the polarization properties are analyzed. We found that the introduction of negative refractive index layers （i.e. LHM medium layers） gives rise to some peculiar band-gap structure and polarization properties as follows. Firstly, the forbidden bands are extremely wide and the transmission bands are very sharp without oscillation;and secondly, the change of incident angle has different influences on the forbidden bands of TE and TM modes. For the TM mode, the forbidden band width decreases substantially and finally vanishes, and for the TE mode with central wavelength, the total reflection happens at anv incident anale.展开更多
With the aim to find an absorbing liquid suitable for the gas cleaning system in the application of gasification unit in a remote area, three types of oil were tested using a bubble column and a wetted wall column. Ai...With the aim to find an absorbing liquid suitable for the gas cleaning system in the application of gasification unit in a remote area, three types of oil were tested using a bubble column and a wetted wall column. Air streams containing toluene vapour with flowrates of 13.6 mL-min1 or 27.6 mL.min^-1 were bubbled through a 50 mL static oil in a glass tube at a temperature of 30 ℃ or 60 ℃. In experiments using the wetted wall column, air streams containing toluene were contacted with a falling thin film ofoil on the outer wall of a column with a diameter of 6.4 cm and two different contacting heights of 60 cm or 80 cm. Toluene concentrations in the air stream were adjusted in the range of 700-3000 ppm corresponding to a typical tars concentration in the producer gas. The phase equilibrium of toluene was represented as values of 1/tl of 326, 220 and 182 respectively for lubrication oil, palm oil and sunflower oil （H is Henry＇s constant with the toluene concentrations in g.L^-1 for liquid phase and g.Nm^-3 for gas phase）. From experiments using the bubble column, it was found that the overall mass transfer coefficient （Kc, a） was in the order of 10.3 cm3-min^-1 and the overall liquid phase mass transfer coefficient （KLa）was about 10.3 cm3.min^-1. Although lubrication oil had a slightly better absorption capacity than the other two tested oils, it had a lower mass trasfer coefficient than that of palm oil. All three proposed oils had a much better absorption capacity and absorption rate than that of water used conventionally as a scrubbing liquid in a small biomass gasification plant.展开更多
There is low formation pressure coefficient and high formation temperature in ludong-wucaiwan area. Gas cut and gas channeling happen seriously during oil and gas well cementing. The existing anti-migration additive h...There is low formation pressure coefficient and high formation temperature in ludong-wucaiwan area. Gas cut and gas channeling happen seriously during oil and gas well cementing. The existing anti-migration additive has only effects on single trait, so it is difficult to meet cementing requirement. According to this situation we could use latex slurry to anti-gas channeling. We have synthesised a set of anti-gas channeling lightweight temperature-resistant latex slurry and formed a new channeling preventing latex slurry through plenty of previous laboratory experiments. Finally the performance of latex slurry on temperature-resistant, anti-gas channeling and the anti-gas channeling of cement paste are studied. The experimental results show that this latex system has strong temperature-resistant and anti-gas channeling, which completely meet the requirement of cementing in this area.展开更多
The impact force response of a peach impacting on a metal flat-surface was considered as nondestructive determination of firmness. The objectives were to analyze the effect of firmness, drop height, fruit mass, and im...The impact force response of a peach impacting on a metal flat-surface was considered as nondestructive determination of firmness. The objectives were to analyze the effect of firmness, drop height, fruit mass, and impact orientation on the impact force parameters, and to establish a relationship between the impact force parameter and firmness. The effect of fruit firmness, drop height and fruit mass on the impact force parameters (coefficient of restitution, percentage of energy absorbed, and coefficient of force-time) was evaluated. The study found that the coefficient of restitution, percentage of energy absorbed, and force-time impact coefficient were significantly affected by fruit ripeness, but not affected by drop height, impact position (fruit cheek), and mass. The percentage of absorbed energy increased with ripeness, while the force-time impact coefficient and coefficient of restitution decreased with ripeness. Relationships were obtained between the three impact characteristic parameters (force-time impact coefficient, coefficient of restitution, and percentage of energy absorbed) and peach firmness using a polynomial model (R2=0.932), S model (R2=0.910), and exponential model (R2=0.941), respectively.展开更多
文摘Based on the Chinese National Standards involving heat pump water heater and space heating system, performances of the R744/R290 subcritical heat pump system have been discussed and compared with those of the R22 system, which is widely used in heat pump systems in China nowadays. It can be indicated that R744/R290 mixture can work efficiently as a refrigerant for heat pumps with a large heat-sink temperature rise. When mass fraction of R290 is increased, discharge pressure is reduced. Under the nominal working condition, there is an optimum mixture mass fraction of 20/80 for R744/R290 under conventional condensation pressure. Both the heating COPhs （coefficient of performance） and volumetric heating capacity are increased by about 12.62% and 34.24% respectively compared with those of R22 based system. But for the heat sink with a small temperature rise, R744/R290 system has poorer performances than R22 system. When heat transfer pinch point in evaporator and condensation processes is considered, the degree of superheat has a negative influence upon system performances under the given conditions.
文摘We introduce a new model of one-dimensional （1D） photonic crystal composed of alternately arranged RHM and LHM layers with positive and negative refractive indices respectively, for which the transmission spectra of the model are calculated numerically with the transfer matrix method, and the bandgap structure and the polarization properties are analyzed. We found that the introduction of negative refractive index layers （i.e. LHM medium layers） gives rise to some peculiar band-gap structure and polarization properties as follows. Firstly, the forbidden bands are extremely wide and the transmission bands are very sharp without oscillation;and secondly, the change of incident angle has different influences on the forbidden bands of TE and TM modes. For the TM mode, the forbidden band width decreases substantially and finally vanishes, and for the TE mode with central wavelength, the total reflection happens at anv incident anale.
文摘With the aim to find an absorbing liquid suitable for the gas cleaning system in the application of gasification unit in a remote area, three types of oil were tested using a bubble column and a wetted wall column. Air streams containing toluene vapour with flowrates of 13.6 mL-min1 or 27.6 mL.min^-1 were bubbled through a 50 mL static oil in a glass tube at a temperature of 30 ℃ or 60 ℃. In experiments using the wetted wall column, air streams containing toluene were contacted with a falling thin film ofoil on the outer wall of a column with a diameter of 6.4 cm and two different contacting heights of 60 cm or 80 cm. Toluene concentrations in the air stream were adjusted in the range of 700-3000 ppm corresponding to a typical tars concentration in the producer gas. The phase equilibrium of toluene was represented as values of 1/tl of 326, 220 and 182 respectively for lubrication oil, palm oil and sunflower oil （H is Henry＇s constant with the toluene concentrations in g.L^-1 for liquid phase and g.Nm^-3 for gas phase）. From experiments using the bubble column, it was found that the overall mass transfer coefficient （Kc, a） was in the order of 10.3 cm3-min^-1 and the overall liquid phase mass transfer coefficient （KLa）was about 10.3 cm3.min^-1. Although lubrication oil had a slightly better absorption capacity than the other two tested oils, it had a lower mass trasfer coefficient than that of palm oil. All three proposed oils had a much better absorption capacity and absorption rate than that of water used conventionally as a scrubbing liquid in a small biomass gasification plant.
文摘There is low formation pressure coefficient and high formation temperature in ludong-wucaiwan area. Gas cut and gas channeling happen seriously during oil and gas well cementing. The existing anti-migration additive has only effects on single trait, so it is difficult to meet cementing requirement. According to this situation we could use latex slurry to anti-gas channeling. We have synthesised a set of anti-gas channeling lightweight temperature-resistant latex slurry and formed a new channeling preventing latex slurry through plenty of previous laboratory experiments. Finally the performance of latex slurry on temperature-resistant, anti-gas channeling and the anti-gas channeling of cement paste are studied. The experimental results show that this latex system has strong temperature-resistant and anti-gas channeling, which completely meet the requirement of cementing in this area.
基金Project supported by the National Natural Science Foundation of China (No. 30570449)the Program for New Century Excellent Talents in Chinese University (No. NCET-04-0544)
文摘The impact force response of a peach impacting on a metal flat-surface was considered as nondestructive determination of firmness. The objectives were to analyze the effect of firmness, drop height, fruit mass, and impact orientation on the impact force parameters, and to establish a relationship between the impact force parameter and firmness. The effect of fruit firmness, drop height and fruit mass on the impact force parameters (coefficient of restitution, percentage of energy absorbed, and coefficient of force-time) was evaluated. The study found that the coefficient of restitution, percentage of energy absorbed, and force-time impact coefficient were significantly affected by fruit ripeness, but not affected by drop height, impact position (fruit cheek), and mass. The percentage of absorbed energy increased with ripeness, while the force-time impact coefficient and coefficient of restitution decreased with ripeness. Relationships were obtained between the three impact characteristic parameters (force-time impact coefficient, coefficient of restitution, and percentage of energy absorbed) and peach firmness using a polynomial model (R2=0.932), S model (R2=0.910), and exponential model (R2=0.941), respectively.
